PANORAMIC VIEW MONITOR SYSTEM PRECAUTION

PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE BATTERY TERMINAL

IGNITION SWITCH EXPRESSIONS

1. The type of ignition switch used on this model differs depending on the specifications of the vehicle. The expressions listed in the table below are used in this section.

   Expression	Ignition Switch (Position)	Engine Switch (Condition)
   Ignition Switch off	LOCK	Off (Lock)
   Ignition Switch ACC	ACC	On (ACC)
   Ignition Switch ON	ON	On (IG)
   Engine Start	START	On (Start)

POINTS TO NOTE WHEN SERVICING

1. Pay attention to the following points when servicing.

   
   

   1. When disconnecting the cable from the negative (-) battery terminal, "!" may appear on the multi-display. In this case, restore the steering angle neutral point.

      Click here

   2. Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the panoramic view monitor system may be needed.

      Click here

      Tech Tips

      Each adjusted value for the calibration of the panoramic view monitor system will be stored in the parking assist ECU.

   3. A clear image may not be displayed if there is foreign matter such as water drops, snow or mud on the television camera lens. In such a case, wash the lens with a large amount of water and then wipe it with a soft wet cloth. Do not scrub the camera lens as scrubbing may scratch the camera lens and affect the quality of the image.

NOTES FOR EACH TELEVISION CAMERA ASSEMBLY

1. Notes for each television camera assembly

   
   

   1. The panoramic view monitor system may not function properly if subjected to a severe blow by any hard object.

   2. The cover part of the camera is made of resin. If any organic solvent, degreaser, wax or glass coating contacts the cover, immediately wipe it off and wash the cover with water or cracks may develop.

   3. Exposing the camera to a sudden temperature change may affect proper functioning of the camera.

   4. A clear image may not be displayed if there is foreign matter such as water drops, snow or mud on the television camera lens. In such a case, wash the lens with a large amount of water and then wipe it with a soft wet cloth. Do not scrub the camera lens as scrubbing may scratch the camera lens and affect the quality of the image.

   5. When washing the vehicle with a high-pressure washer, do not spray water on the television camera assembly or surrounding area. High-pressure water can damage the camera.

2. Images may be unclear even in normal conditions if:

   
   

   1. Electrical devices are used in the cabin (noise may occur in the image).

   2. Accessories that generate radio waves have been installed (noise may occur in the image).

   3. The outer mirror switch assembly is operated (noise may occur in the image).

   4. The camera lens is frosted over (the image immediately after turning the ignition switch ON may be blurred or darker than normal).

   5. The camera lens is dirty with snow, mud, etc.

   6. A strong beam of light, such as a sunbeam or headlight, hits the camera.

   7. It is too dark around the camera (at night, etc.).

   8. The ambient temperature around the camera is either too high or too low.

   9. The vehicle is tilted at a steep angle.

   10. The television camera assembly lens is scratched.

   11. The television camera assembly lens has drops of water on it or the humidity is high.

   12. When the camera is used under fluorescent lights, sodium lights or mercury lights, etc., the lights and the illuminated area may appear to flicker.