TELEVISION CAMERA(for Side) REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. PRECAUTION

    Click here

  2. REMOVE OUTER MIRROR

    Click here

  3. REMOVE OUTER MIRROR COVER WITH LOWER HOUSING

    Click here

  4. REMOVE SIDE TELEVISION CAMERA ASSEMBLY WITH COVER


    1. A0027A7C02
      *a Claw
      *b Protrusion
      *c Insert Position

      Insert a 0.9 mm (0.0354 in.) spark plug gap gauge or similar tool into the connector as shown in the illustration, lift the claw and disconnect the connector.

      Note


      • Insert the spark plug gap gauge to the point that the claw becomes the same height as the protrusion of the connector housing. If the spark plug gap gauge is inserted too far, or if the claw is lifted directly using a screwdriver, the claw may be damaged.

      • If the claw on the connector is damaged, replace the outer rear view mirror assembly.

    2. A002AMT

      Disconnect the connector to remove the side television camera assembly with cover.

  5. REMOVE SIDE TELEVISION CAMERA ASSEMBLY


    1. A0029B4

      Remove the 2 screws and side television camera assembly.