BLIND SPOT MONITOR SENSOR INSTALLATION

CAUTION / NOTICE / HINT

Note


  • Avoid any impact to the blind spot monitor sensor.

  • Do not drop the blind spot monitor sensor. If it is dropped, replace it with a new one.

Tech Tips


  • The blind spot monitor beam axis confirmation is performed to confirm whether the sensor beam axis is correct, and to adjust the beam axis by using a reflector.

  • The blind spot monitor sensor installation condition inspection is performed to confirm whether the sensor is placed vertically to the ground (+/-4°) by using a jig, and that the sensor is 16 to 24° from the line parallel to the vehicle center line.

PROCEDURE


  1. INSTALL BLIND SPOT MONITOR SENSOR LH


    1. A002ABDC02
      B003ZIE Connector
      B003Z8F Bolt
      B003ZMU Nut

      Connect the connector.

    2. Install the blind spot monitor sensor LH with the bolt and 2 nuts.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

      Note


      • Tighten the bolt and nuts in the order shown in the illustration.

      • Replace the blind spot monitor sensor LH if it has been dropped or subjected to a severe impact.

  2. INSTALL BLIND SPOT MONITOR SENSOR RH


    1. A0029JHC02
      B003ZIE Connector
      B003Z8F Bolt
      B003ZMU Nut

      Connect the connector.

    2. Install the blind spot monitor sensor RH with the bolt and 2 nuts.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

      Note


      • Tighten the bolt and nuts in the order shown in the illustration.

      • Replace the blind spot monitor sensor RH if it has been dropped or subjected to a severe impact.

  3. PERFORM BLIND SPOT MONITOR SENSOR INSTALLATION CONDITION INSPECTION

    Click here

  4. INSTALL REAR BUMPER ASSEMBLY

    Click here

  5. PERFORM BLIND SPOT MONITOR BEAM AXIS CONFIRMATION

    Click here

    SST
    09870-60000   ( 09870-60010 )
    09870-60040

  6. PERFORM DIAGNOSTIC SYSTEM CHECK

    Click here