BLIND SPOT MONITOR SENSOR INSTALLATION

PROCEDURE

1. INSTALL BLIND SPOT MONITOR SENSOR LH

   
   

   1. Install the blind spot monitor sensor LH with the 3 nuts.

      Torque:

      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

      Note

      Replace the blind spot monitor sensor LH if it has been dropped or subjected to a severe impact.

   2. Connect the connector.

2. INSTALL BLIND SPOT MONITOR SENSOR RH

   
   

   1. Install the blind spot monitor sensor RH with the 3 nuts.

      Torque:

      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

      Note

      Replace the blind spot monitor sensor RH if it has been dropped or subjected to a severe impact.

   2. Connect the connector.

3. INSTALL REAR BUMPER ASSEMBLY WITH QUARTER PANEL WHEEL OPENING MOULDING

   Click here

4. PERFORM BLIND SPOT MONITOR BEAM AXIS INSPECTION

   Click here

5. PERFORM BLIND SPOT MONITOR BEAM AXIS CONFIRMATION

   Click here

   SST

   09870-60000   ( 09870-60010 )

   09870-60040

6. PERFORM DIAGNOSTIC SYSTEM CHECK

   Click here