ULTRASONIC SENSOR(for Front Side) INSTALLATION

PROCEDURE


  1. INSTALL FRONT CORNER ULTRASONIC SENSOR RETAINER

    Tech Tips


    • Perform this procedure only when replacement of the front corner ultrasonic sensor retainer is necessary.

    • If a front corner ultrasonic sensor retainer has been removed, replace it with a new one. Install the No. 1 ultrasonic sensor with a new front corner ultrasonic sensor retainer as a set to the front bumper assembly.

    • Use the same procedure for all front corner ultrasonic sensor retainers.


    1. A0027R7

      Engage the 2 claws to install a new front corner ultrasonic sensor retainer to the No. 1 ultrasonic sensor.

    2. Clean the front bumper assembly surface.


      1. Remove any remaining double-sided tape from the front bumper assembly.

      2. Wipe off any tape adhesive residue with cleaner.

    3. A0027DLC03
      *a 18 mm (0.709 in.)

      Cover the sensor installation hole with a 18 mm (0.709 in.) circular piece of tape.

    4. A0028OAC01
      B003ZQH Primer

      Using a brush or felt, apply primer or equivalent to the front corner ultrasonic sensor retainer installation area.

      Note


      • Use a clean brush or felt.

      • Do not touch the front bumper assembly until the primer has dried.

    5. Confirm that the primer has completely dried by touching the front bumper assembly. Then remove the tape.

    6. Peel off the release paper from the new front corner ultrasonic sensor retainer.

    7. A0027P7C01
      *a Scribed Line
      *b Protrusion of the mark

      Align the front corner ultrasonic sensor retainer with No. 1 ultrasonic sensor with the mark on the front bumper assembly and install it as shown in the illustration.

      Note


      • Ensure that the sensor tip is correctly inserted into the sensor installation hole of the front bumper assembly.

      • Ensure that the front corner ultrasonic sensor retainer is within the scribed line.

      • The double-sided tape of a front corner ultrasonic sensor retainer will deteriorate if it is detached. Make sure to replace the front corner ultrasonic sensor retainer with a new one when reattachment is necessary.

      Tech Tips


      • Align the connector with the protrusion of the mark when connecting it.

      • Press the front corner ultrasonic sensor retainer with a force of 30 N (3.0 kgf) for 3 seconds and install the front corner ultrasonic sensor retainer firmly so that there is no clearance between the front corner ultrasonic sensor retainer and front bumper assembly.

  2. INSTALL NO. 1 ULTRASONIC SENSOR

    Tech Tips

    Use the same procedure for all No. 1 ultrasonic sensors.


    1. When replacing only the No. 1 ultrasonic sensor:


      1. Engage the 2 claws to install the No. 1 ultrasonic sensor.

    2. Connect the connector.

  3. INSTALL FRONT BUMPER ASSEMBLY

    Click here