AMPLIFIER ANTENNA INSTALLATION

PROCEDURE


  1. INSTALL NO. 1 AMPLIFIER ANTENNA ASSEMBLY

    Tech Tips

    Butyl tape and adhesive tape are not available as supply parts. If these pieces of tape still have enough adhesion to secure the No. 1 amplifier antenna assembly to the roof headlining assembly, reuse them. If the adhesive tape and/or the butyl tape is no longer sticky, apply new tape following the procedure below.


    1. Apply new butyl tape.

      A0029H2C01
      *a Marking - -
      B004057 Butyl tape B003Z8F Front

      1. Remove the old butyl tape from the roof headlining assembly.

      2. Prepare the appropriate amount of new butyl tape.

        Tech Tips

        Be careful not to touch the adhesive surface.

      3. Apply the butyl tape to the roof headlining assembly while aligning the tape with the markings on the roof headlining assembly.

      4. Peel off the release paper from the butyl tape.

    2. Install the No. 1 amplifier antenna assembly to the roof headlining assembly from the rear of the roof headlining assembly.

      A0027PAC02
      *a Protrusion *b Adjustment Area
      B004057 Adhesive Tape A002BBM Marking Tape
      B003Z8F Front - -

    3. Connect the connector.

    4. Put the pieces of tape back to the positions shown in the illustration in order to secure the No. 1 amplifier antenna assembly and washer hose to the roof headlining assembly.

      Tech Tips


      • If the tape is no longer sticky, use other tape, such as packing tape, that has enough adhesion to secure the antenna cord to the roof headlining assembly.

      • Align the marking tape on the No. 1 amplifier antenna assembly with the protrusion of the roof headlining assembly, and wrap tape around the No. 1 amplifier antenna assembly and roof headlining assembly once or twice to to securely hold them.

      • Secure the extra length of the No. 1 amplifier antenna assembly in the adjustment area shown in the illustration.

  2. INSTALL ROOF HEADLINING ASSEMBLY

    Click here