REAR SEAT ENTERTAINMENT SYSTEM Television Display Power Source Circuit

DESCRIPTION

This is the power source circuit to operate the television display assembly.

WIRING DIAGRAM

A018HJME01
*a from Battery
*b RADIO
*c from ACC Relay
*d Television Display Assembly

CAUTION / NOTICE / HINT

Note

Inspect the fuses for circuits related to this system before performing procedure.

PROCEDURE


  1. CHECK HARNESS AND CONNECTOR (TELEVISION DISPLAY ASSEMBLY POWER SOURCE)


    1. Disconnect the S8 television display assembly connector.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      S8-17 (GND) - Body ground Always Below 1 Ω

    3. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      S8-1 (+B) - S8-17 (GND) Always 11 to 14 V
      S8-2 (ACC) - S8-17 (GND) Engine switch on (ACC) 11 to 14 V
      Result
      Proceed to
      OK
      NG

    OK

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR