REAR SEAT ENTERTAINMENT SYSTEM AVC-LAN Circuit

DESCRIPTION

Each unit of the rear seat entertainment system connected to the AVC-LAN (communication bus) transmits switch signals through the AVC-LAN.

If a short to +B or short to ground occurs in the AVC-LAN, the rear seat entertainment system will not function normally because communication is not possible.

WIRING DIAGRAM

A018M71E08
*a Navigation Receiver Assembly
*b Television Display Assembly
*c AVC-LAN Communication Line

CAUTION / NOTICE / HINT

Tech Tips

The navigation receiver assembly is the master unit.

PROCEDURE


  1. INSPECT NAVIGATION RECEIVER ASSEMBLY


    1. Remove the navigation receiver assembly.

      Click here

    2. A002C7GC01
      *a

      Component without harness connected

      (Navigation Receiver Assembly)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      9 (TX+) - 10 (TX-) Always 60 to 80 Ω
      Result
      Proceed to
      OK
      NG

    NG

    REPLACE NAVIGATION RECEIVER ASSEMBLY Click here

    OK

  2. CHECK HARNESS AND CONNECTOR (AVC-LAN CIRCUIT)


    1. Disconnect the F118 navigation receiver assembly connector.

    2. Disconnect the S8 television display assembly connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      S8-3 (TX1+) - F118-9 (TX+) Always Below 1 Ω
      S8-4 (TX1-) - F118-10 (TX-) Always Below 1 Ω
      S8-3 (TX1+) - Body ground Always 10 kΩ or higher
      S8-4 (TX1-) - Body ground Always 10 kΩ or higher
      Result
      Proceed to
      OK
      NG

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  3. INSPECT MALFUNCTIONING PARTS


    1. Disconnect and reconnect each slave unit one by one until the master unit returns to normal operation.

      Tech Tips


      • Check all slave units.

      • If disconnecting a slave unit causes the master unit to return to normal operation, the slave unit is defective and should be replaced.

      OK
      Master unit returns to normal operation.
      Result
      Proceed to
      OK
      NG

    OK

    REPLACE MALFUNCTIONING PARTS

    NG

    REPLACE NAVIGATION RECEIVER ASSEMBLY Click here