DESCRIPTION
The navigation receiver assembly controls the volume according to the mute signal from the television display assembly.
The mute signal is sent to reduce noise and popping sounds, such as those generated when switching modes.
If there is an open in the circuit, noise can be heard from the speakers when changing the sound source.
If there is a short in the circuit, even though the navigation receiver assembly is functioning normally, no sound or only an extremely faint sound can be heard.
WIRING DIAGRAM
| *1 | MUTE |
| *2 | Navigation Receiver Assembly |
| *3 | Television Display Assembly |
PROCEDURE
INSPECT TELEVISION DISPLAY ASSEMBLY
| *a | Component with harness connected (Television Display Assembly) |
Measure the voltage according to the value(s) in the table below.
| Standard Voltage | ||||||
|---|---|---|---|---|---|---|
|
| Result | |||
|---|---|---|---|
|
| OK |
|
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here |
| NG |
|
CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - TELEVISION DISPLAY ASSEMBLY)
Disconnect the F118 navigation receiver assembly connector.
Disconnect the S8 television display assembly connector.
Measure the resistance according to the value(s) in the table below.
| Standard Resistance | |||||||||
|---|---|---|---|---|---|---|---|---|---|
|
| Result | |||
|---|---|---|---|
|
| NG |
|
REPAIR OR REPLACE HARNESS OR CONNECTOR |
| OK |
|
REPLACE TELEVISION DISPLAY ASSEMBLY
Replace the television display assembly and check if it operates normally.
| OK |
|---|
| The rear seat entertainment system operates normally. |
| Result | |||
|---|---|---|---|
|
| OK |
|
END (TELEVISION DISPLAY ASSEMBLY WAS DEFECTIVE) |
| NG |
|
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here |