STEERING COLUMN ASSEMBLY REMOVAL

CAUTION / NOTICE / HINT

Note

Make sure to select DEF mode before disconnecting the cable from the negative (-) battery terminal (for RHD).

PROCEDURE


  1. PRECAUTION

    Click here

  2. ALIGN FRONT WHEELS FACING STRAIGHT AHEAD

  3. REMOVE FRONT WHEEL

  4. REMOVE HORN BUTTON ASSEMBLY

    Click here

  5. REMOVE STEERING WHEEL ASSEMBLY

    Click here

  6. REMOVE LOWER STEERING COLUMN COVER


    1. A0027HC

      Remove the 2 screws.

    2. A0028WG

      Disengage the 2 claws.

    3. A0029OS

      Disengage the claw and remove the lower steering column cover.

  7. REMOVE UPPER STEERING COLUMN COVER


    1. A0028XL

      Disengage the 6 clips from the upper steering column cover.

    2. A002B4G

      Disengage the 2 claws and remove the upper steering column cover.

  8. REMOVE TURN SIGNAL SWITCH ASSEMBLY WITH SPIRAL CABLE SUB-ASSEMBLY

    Note


    • Do not replace the spiral cable with sensor sub-assembly with the battery connected and the ignition switch ON.

    • Do not rotate the spiral cable with sensor sub-assembly without the steering wheel assembly with the battery connected and the ignition switch ON.

    • Ensure that the steering wheel assembly is installed and aligned straight when inspecting the steering sensor.


    1. Disconnect each connector from the turn signal switch assembly with spiral cable sub-assembly.

    2. A002A1K

      Disengage the 3 claws to remove the turn signal switch assembly with spiral cable sub-assembly from the steering column assembly.

  9. REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY

    Click here

  10. SEPARATE STEERING INTERMEDIATE SHAFT ASSEMBLY


    1. A002CD4

      Loosen the bolt.

    2. A0027FSC01
      *a Matchmark

      Put matchmarks on the steering intermediate shaft assembly and the steering link assembly.

    3. Remove the bolt and separate the steering intermediate shaft assembly from the steering link assembly.

  11. REMOVE NO. 4 AIR DUCT SUB-ASSEMBLY (for LHD)


    1. Remove the bolt.

    2. A0029CB

      Disengage the 2 claws and guide to remove the No. 4 air duct sub-assembly.

  12. REMOVE NO. 3 AIR DUCT SUB-ASSEMBLY (for RHD)


    1. A002C07

      Disengage the 2 claws and guide to remove the No. 3 air duct sub-assembly.

  13. REMOVE BRAKE PEDAL SUPPORT ASSEMBLY

    for LHD: Click here

    for RHD: Click here

  14. REMOVE STEERING POST ASSEMBLY


    1. Disconnect each connector and disengage each wire harness clamp from the steering post assembly.

    2. A0028G6

      Remove the bolt to separate the ground wire.

    3. Disengage the 2 clamps.

    4. Disconnect the 2 connectors.

    5. A002CMQ

      Remove the bolt, 2 nuts and steering post assembly.