STEERING WHEEL REMOVAL

CAUTION / NOTICE / HINT

Note


  • Do not replace the spiral cable with sensor sub-assembly with the battery connected and the ignition switch ON.

  • Do not rotate the spiral cable with sensor sub-assembly without the steering wheel assembly with the battery connected and the ignition switch ON.

  • Ensure that the steering wheel assembly is installed and aligned straight when inspecting the steering sensor.

PROCEDURE


  1. ALIGN FRONT WHEELS FACING STRAIGHT AHEAD

  2. REMOVE HORN BUTTON ASSEMBLY

    Click here

  3. REMOVE STEERING WHEEL ASSEMBLY


    1. Disconnect each connector from the spiral cable with sensor sub-assembly.

    2. w/ Steering Heater:


      1. A002C12

        Disconnect the connector from the steering wheel heater control assembly.

    3. A002984C01
      *a Matchmark

      Remove the steering wheel assembly set nut.

    4. Put matchmarks on the steering wheel assembly and steering main shaft.

    5. A0028I7C01
      *a Turn
      *b Hold

      Using SST, remove the steering wheel assembly.

      SST
      09950-50013   ( 09951-05010, 09952-05010, 09953-05020, 09954-05070 )

      Note

      Apply a small amount of grease to the threads and tip of SST (09953-05020) before use.

  4. REMOVE STEERING PAD SWITCH ASSEMBLY

    Click here

  5. REMOVE CRUISE CONTROL MAIN SWITCH

    Click here

  6. REMOVE CRUISE CONTROL SWITCH WIRE


    1. Remove the cruise control switch wire.

  7. REMOVE STEERING WHEEL HEATER CONTROL ASSEMBLY (w/ Steering Heater)

    Click here

  8. REMOVE STEERING SHAKE DAMPER (for 2GR-FE)


    1. A002A93

      Remove the 2 screws and steering shake damper from the steering wheel assembly.