PARKING BRAKE ASSEMBLY DISASSEMBLY

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. REMOVE REAR WHEEL

  2. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY

    Click here

  3. REMOVE PARKING BRAKE SHOE ADJUSTING HOLE PLUG

  4. REMOVE REAR DISC

    Click here

  5. REMOVE PARKING BRAKE SHOE RETURN TENSION SPRING (for Upper Side)


    1. A018LHY

      Remove the 2 parking brake shoe return tension springs.

      Note

      Be sure to put an identification mark on each parking brake shoe return tension spring so that it can be reinstalled to its original position.

  6. SEPARATE NO. 1 PARKING BRAKE SHOE ASSEMBLY


    1. A018IFA

      Remove the parking brake shoe hold down spring cup and parking brake shoe hold down compression spring to separate the No. 1 parking brake shoe assembly from the backing plate.

  7. REMOVE PARKING BRAKE SHOE LEVER STRUT


    1. A018H3E

      Pull the No. 1 parking brake shoe assembly towards the front of the vehicle by hand as shown in the illustration.

    2. A018IMG

      Remove the parking brake shoe lever strut.

  8. REMOVE PARKING BRAKE SHOE STRUT COMPRESSION SPRING


    1. A018HBI

      Remove the parking brake shoe strut compression spring.

  9. SEPARATE NO. 2 PARKING BRAKE SHOE ASSEMBLY


    1. A018LQZ

      Remove the parking brake shoe hold down spring cup and parking brake shoe hold down compression spring to separate the No. 2 parking brake shoe assembly from the backing plate.

  10. REMOVE PARKING BRAKE SHOE ADJUSTING SCREW SET


    1. A018HUP

      Remove the parking brake shoe adjusting screw set.

  11. REMOVE NO. 1 PARKING BRAKE SHOE ASSEMBLY


    1. A018LWX

      Remove the No. 1 parking brake shoe assembly.

  12. REMOVE PARKING BRAKE SHOE RETURN TENSION SPRING (for Lower Side)


    1. A018LJB

      Remove the parking brake shoe return tension spring.

  13. SEPARATE PARKING BRAKE SHOE LEVER


    1. A018KWM

      Using needle-nose pliers, separate the parking brake shoe lever from the No. 3 parking brake cable assembly.

      Note

      Be careful not to damage the No. 3 parking brake cable assembly.

  14. REMOVE PARKING BRAKE SHOE LEVER


    1. A018KKM

      Using a screwdriver, remove the parking brake shoe type C washer, parking brake shoe shim and parking brake shoe lever.

      Tech Tips

      Parking brake shoe shims are provided when necessary to adjust the clearance between the parking brake shoe lever and parking brake shoe type C washer. Some vehicles may not be equipped with shims.

  15. REMOVE PARKING BRAKE SHOE HOLD DOWN SPRING PIN


    1. for Front Side:


      1. A018HOP

        Remove the parking brake shoe hold down spring pin.

    2. for Rear Side:


      1. A018L1A

        Remove the parking brake shoe hold down spring pin.

  16. REMOVE PARKING BRAKE SHOE GUIDE PLATE


    1. A018HUB

      Remove the parking brake shoe guide plate set bolt and parking brake shoe guide plate.