REAR BRAKE FLEXIBLE HOSE INSTALLATION

CAUTION / NOTICE / HINT

Note


  • Because the left and right rear flexible hoses are not interchangeable, verify the part number when installing the rear flexible hoses.

  • If the rear flexible hoses are to be reused, connect them after checking the identification marks placed when each hose was disconnected.

Tech Tips


  • Use the same procedure for the LH side and RH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. INSTALL FLEXIBLE HOSE BRACKET


    1. Install the flexible hose bracket to the rear upper control arm assembly with the bolt.

      Torque:
      18.8 N*m  { 192 kgf*cm, 14 ft.*lbf }

  2. INSTALL REAR FLEXIBLE HOSE

    Note

    When installing the rear flexible hose, minimize twisting of the hose.


    1. A002BPSC01
      *a Identification Mark

      Install a new clip to the rear flexible hose.

      Note


      • Install the clip as far as it will go.

      • When installing the rear flexible hose, face the identification mark to the outside of the vehicle.

    2. Using a union nut wrench, connect the brake line to the rear flexible hose while holding the rear flexible hose with a wrench.

      Torque:
      15.2 N*m  { 155 kgf*cm, 11 ft.*lbf }

      Note


      • Do not kink or damage the brake line.

      • Do not allow any foreign matter such as dirt or dust to enter the brake line from the connecting parts.

      • Use the formula to calculate special torque values for situations where the union nut wrench is combined with a torque wrench.

        Click here

    3. Install the rear flexible hose to the flexible hose bracket with the 2 bolts.

      Torque:
      18.8 N*m  { 192 kgf*cm, 14 ft.*lbf }

    4. Connect the rear flexible hose to the rear disc brake cylinder assembly with a new union bolt and a new gasket.

      Torque:
      22 N*m  { 224 kgf*cm, 16 ft.*lbf }

      Note

      Install the rear flexible hose lock securely into the lock hole in the rear disc brake cylinder assembly.

  3. BLEED BRAKE LINE

    Click here

  4. INSTALL REAR WHEEL

    Torque:
    103 N*m  { 1050 kgf*cm, 76 ft.*lbf }