REAR SPEED SENSOR(for 2WD) INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the LH side and RH side.

  • The following procedure is for the LH side.

  • The rear speed sensor is a component of the rear axle hub and bearing assembly. If the rear speed sensor is malfunctioning, replace the rear axle hub and bearing assembly.

  • If the rear speed sensor rotor needs to be replaced, replace the rear axle hub and bearing assembly.

PROCEDURE


  1. INSTALL REAR AXLE HUB AND BEARING ASSEMBLY


    1. Install the rear axle hub and bearing assembly.

      Click here

      Tech Tips


      • The rear speed sensor is a component of the rear axle hub and bearing assembly. If the rear speed sensor is malfunctioning, replace the rear axle hub and bearing assembly.

      • If the rear speed sensor rotor needs to be replaced, replace the rear axle hub and bearing assembly.

  2. INSPECT REAR AXLE HUB BEARING LOOSENESS

    Click here

  3. INSPECT REAR AXLE HUB RUNOUT

    Click here

  4. INSTALL SKID CONTROL SENSOR WIRE


    1. Connect the connector to the rear speed sensor.

      Note

      Do not twist the skid control sensor wire.

    2. Install the skid control sensor wire with the bolt.

      Torque:
      8.0 N*m  { 82 kgf*cm, 71 in.*lbf }

  5. INSTALL REAR DISC

    Click here

  6. INSTALL PARKING BRAKE SHOE ADJUSTING HOLE PLUG

    Click here

  7. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY

    Click here

  8. INSTALL REAR SUSPENSION ARM COVER

    Click here

  9. ADJUST PARKING BRAKE

    Click here

  10. INSTALL REAR WHEEL

    Torque:
    103 N*m  { 1050 kgf*cm, 76 ft.*lbf }

  11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  12. CHECK FOR SPEED SENSOR SIGNAL

    Click here