REAR TRAILING ARM INSTALLATION

CAUTION / NOTICE / HINT

PROCEDURE


  1. INSTALL REAR TRAILING ARM ASSEMBLY


    1. A0027KHC01
      *a Wooden Block
      *b Jack

      Support the rear No. 2 suspension arm assembly using a jack and wooden block.

      CAUTION:

      Do not jack up the rear No. 2 suspension arm assembly too high as the vehicle may fall.

      Note

      When jacking up the rear No. 2 suspension arm assembly, be sure to jack it up slowly.

    2. A002ARUN01

      Install the rear trailing arm assembly to the rear axle carrier sub-assembly with the 2 bolts (A) and 2 washers.

      Torque:
      150 N*m  { 1530 kgf*cm, 111 ft.*lbf }

    3. Install the rear trailing arm assembly to the body with the 2 bolts (B).

      Torque:
      150 N*m  { 1530 kgf*cm, 111 ft.*lbf }

    4. Slowly lower the rear No. 2 suspension arm assembly.

    5. A002CGS

      Install the No. 3 parking brake cable assembly to the rear trailing arm assembly with the 2 bolts.

      Torque:
      18.8 N*m  { 192 kgf*cm, 14 ft.*lbf }

      Note

      Do not twist the No. 3 parking brake cable assembly when installing it.

  2. INSTALL REAR SPEED SENSOR (for AWD)


    1. A002CFG

      Install the rear speed sensor to the rear trailing arm assembly with the bolt.

      Torque:
      8.0 N*m  { 82 kgf*cm, 71 in.*lbf }

      Note

      Do not twist the rear speed sensor when installing it.

  3. INSTALL REAR SUSPENSION ARM COVER

    Click here

  4. INSTALL REAR WHEEL

    Torque:
    103 N*m  { 1050 kgf*cm, 76 ft.*lbf }

  5. INSPECT AND ADJUST REAR WHEEL ALIGNMENT

    Click here