REAR TRAILING ARM REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. REMOVE REAR WHEEL

  2. REMOVE REAR SUSPENSION ARM COVER

    Click here

  3. SEPARATE REAR SPEED SENSOR (for AWD)


    1. A002CFG

      Remove the bolt and separate the rear speed sensor from the rear trailing arm assembly.

  4. REMOVE REAR TRAILING ARM ASSEMBLY


    1. A002CGS

      Remove the 2 bolts and separate the No. 3 parking brake cable assembly from the rear trailing arm assembly.

    2. A0027KHC01
      *a Wooden Block
      *b Jack

      Support the rear No. 2 suspension arm assembly using a jack and wooden block.

      CAUTION:

      Do not jack up the rear No. 2 suspension arm assembly too high as the vehicle may fall.

      Note

      When jacking up the rear No. 2 suspension arm assembly, be sure to jack it up slowly.

    3. A002ARU

      Remove the 4 bolts, 2 washers and rear trailing arm assembly.

    4. Slowly lower the rear No. 2 suspension arm assembly.