REAR UPPER ARM INSTALLATION

PROCEDURE


  1. INSTALL REAR UPPER CONTROL ARM ASSEMBLY LH


    1. A002BP3

      Temporarily install the rear upper control arm assembly LH to the rear suspension member sub-assembly with the bolt and nut.

      Note


      • Because the nut has its own stopper, do not turn the nut. Tighten the bolt with the nut secured.

      • Insert the bolt with the threaded end facing the rear of the vehicle.

    2. A002BISN02

      Set the rear upper control arm assembly LH in the tightening position as shown in the illustration.

      Reference Length (A)
      24.3 mm (0.957 in.)
    3. A002BP3

      Fully tighten the bolt.

      Torque:
      120 N*m  { 1224 kgf*cm, 89 ft.*lbf }

      Note

      Because the nut has its own stopper, do not turn the nut. Tighten the bolt with the nut secured.

  2. INSTALL REAR UPPER CONTROL ARM ASSEMBLY RH

    Tech Tips

    Perform the same procedure as for the LH side.

  3. INSTALL SKID CONTROL SENSOR WIRE LH (for 2WD)

    A002B3V

    1. Install the skid control sensor wire LH to the rear upper control arm assembly LH with the 2 bolts.

      Torque:
      8.0 N*m  { 82 kgf*cm, 71 in.*lbf }

      Note

      Do not twist the skid control sensor wire LH when installing it.

  4. INSTALL REAR SPEED SENSOR LH (for AWD)

    Tech Tips

    Perform the same procedure as for the skid control sensor wire LH.

  5. INSTALL SKID CONTROL SENSOR WIRE RH (for 2WD)


    1. A0027XQ

      Install the skid control sensor wire RH to the rear upper control arm assembly RH with the 2 bolts.

      Torque:
      8.0 N*m  { 82 kgf*cm, 71 in.*lbf }

      Note

      Do not twist the skid control sensor wire RH when installing it.

  6. INSTALL REAR SPEED SENSOR RH (for AWD)

    Tech Tips

    Perform the same procedure as for the skid control sensor wire RH.

  7. INSTALL REAR SUSPENSION MEMBER SUB-ASSEMBLY

    for 2WD: Click here

    for AWD: Click here