FRONT STABILIZER BAR(When Using the Engine Support Bridge for AWD) INSTALLATION

PROCEDURE


  1. INSTALL FRONT NO. 1 STABILIZER BAR BUSHING


    1. A002A8YC01
      *a Cutout
      B003ZIE Front of the Vehicle
      B003Z8F Inside of the Vehicle

      Install the 2 front No. 1 stabilizer bar bushings to the front stabilizer bar as shown in the illustration.

      Note

      When installing the front No. 1 stabilizer bar bushings, make sure that the cutout is facing the rear of the vehicle.

  2. INSTALL FRONT NO. 2 STABILIZER BRACKET LH


    1. Install the front No. 2 stabilizer bracket LH to the front No. 1 stabilizer bar bushing.

  3. INSTALL FRONT NO. 2 STABILIZER BRACKET RH

    Tech Tips

    Perform the same procedure as for the LH side.

  4. INSTALL FRONT NO. 1 STABILIZER BRACKET LH


    1. Install the front No. 1 stabilizer bracket LH to the front No. 1 stabilizer bar bushing.

  5. INSTALL FRONT NO. 1 STABILIZER BRACKET RH

    Tech Tips

    Perform the same procedure as for the LH side.

  6. TEMPORARILY INSTALL FRONT STABILIZER BAR


    1. Temporarily install the front stabilizer bar to the vehicle body.

      Note

      Use wire or an equivalent tool to secure the front stabilizer bar.

  7. INSTALL FRONT FRAME ASSEMBLY

    Click here

  8. INSTALL FRONT STABILIZER LINK ASSEMBLY LH


    1. Install the front stabilizer link assembly LH to the front shock absorber assembly and front stabilizer bar with the 2 nuts.

      Torque:
      74 N*m  { 755 kgf*cm, 55 ft.*lbf }

      Tech Tips

      If the ball joint turns together with the nut, use a 6 mm hexagon wrench to hold the stud bolt.

  9. INSTALL FRONT STABILIZER LINK ASSEMBLY RH

    Tech Tips

    Perform the same procedure as for the LH side.

  10. INSTALL FRONT WHEELS

  11. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT

    Click here