REAR AXLE HUB INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. INSTALL REAR AXLE HUB AND BEARING ASSEMBLY (for 2WD)


    1. A00293L

      Install the rear axle hub and bearing assembly to the rear axle carrier sub-assembly with the 4 bolts.

      Torque:
      125 N*m  { 1275 kgf*cm, 92 ft.*lbf }

  2. INSTALL REAR AXLE HUB AND BEARING ASSEMBLY (for AWD)


    1. A002C5TC01
      *a Matchmark

      Install the rear axle hub and bearing assembly to the rear drive shaft assembly.

      Note

      Align the matchmarks on the rear drive shaft assembly and rear axle hub and bearing assembly.

    2. A002ACO

      Install the rear axle hub and bearing assembly to the rear axle carrier sub-assembly with the 4 bolts.

      Torque:
      125 N*m  { 1275 kgf*cm, 92 ft.*lbf }

  3. TEMPORARILY INSTALL REAR AXLE SHAFT NUT (for AWD)


    1. Clean the threaded parts on the rear drive shaft assembly and a new rear axle shaft nut using non-residue solvent.

      Note


      • Be sure to perform this work even when using a new rear drive shaft assembly.

      • Keep the threaded parts free of oil and foreign matter.

    2. Temporarily install the rear disc with the 5 hub nuts.

    3. A002CKI

      Using a 30 mm socket wrench, while applying the parking brakes, temporarily install the rear axle shaft nut.

      Torque:
      294 N*m  { 2998 kgf*cm, 217 ft.*lbf }

      Note

      Stake the rear axle shaft nut after inspecting for looseness and runout in the following steps.

    4. Remove the 5 hub nuts and the rear disc.

  4. INSPECT REAR AXLE HUB BEARING LOOSENESS

    Click here

  5. INSPECT REAR AXLE HUB RUNOUT

    Click here

  6. INSTALL SKID CONTROL SENSOR WIRE (for 2WD)

    Click here

  7. INSTALL REAR SPEED SENSOR (for AWD)


    1. A002BK7

      Install the rear speed sensor to the rear axle carrier sub-assembly with the bolt.

      Torque:
      8.5 N*m  { 87 kgf*cm, 75 in.*lbf }

      Note

      Do not twist the rear speed sensor when installing it.

  8. INSTALL REAR DISC

    Click here

  9. INSTALL PARKING BRAKE SHOE ADJUSTING HOLE PLUG

    Click here

  10. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY

    Click here

  11. STAKE REAR AXLE SHAFT NUT (for AWD)


    1. A002AY0

      Using a chisel and hammer, stake the rear axle shaft nut.

  12. INSTALL REAR SUSPENSION ARM COVER

    Click here

  13. ADJUST PARKING BRAKE

    Click here

  14. INSTALL REAR WHEEL

    Torque:
    103 N*m  { 1050 kgf*cm, 76 ft.*lbf }

  15. CHECK FOR SPEED SENSOR SIGNAL

    Click here