REAR DRIVE SHAFT ASSEMBLY(for AWD) INSPECTION

PROCEDURE


  1. INSPECT REAR DRIVE SHAFT ASSEMBLY


    1. A0029K5

      Check that there is no excessive play in the radial direction of the outboard joint.

    2. Check that the inboard joint slides smoothly in the thrust direction.

    3. Check that there is no excessive play in the radial direction of the inboard joint.

    4. Check the boots for damage.

    5. B003YWKN07

      Check whether each drive shaft dimension (A) is within specification.

      Note

      Keep the drive shaft assembly level during inspection.

      Dimension (A)
      for LH Side 758.25 mm (2.49 ft.)
      for RH Side 738.25 mm (2.42 ft.)