SEAT POSITION SENSOR INSTALLATION

PROCEDURE


  1. INSTALL SEAT POSITION AIRBAG SENSOR (for Manual Seat)


    1. A0028OR

      Engage the pin to install the seat position airbag sensor to the seat slide position sensor protector as shown in the illustration.

    2. A0027OPC04
      *1 Seat Position Airbag Sensor
      *a Feeler Gauge
      *b 1.3 mm (0.0512 in.)
      *c Seat Rail

      Using a 1.3 mm (0.0512 in.) feeler gauge, temporarily install the seat position airbag sensor with the "TORX" bolt.

      Note


      • If the seat position airbag sensor has been dropped, or there are any cracks, dents or other defects in the case or connector, replace the seat position airbag sensor with a new one.

      • When installing the seat position airbag sensor, be careful that the SRS wiring does not interfere with or is pinched between other parts.

    3. Using a T30 "TORX" socket wrench, tighten the "TORX" bolt.

      Torque:
      8.0 N*m  { 82 kgf*cm, 71 in.*lbf }

    4. Make sure that the clearance between the seat position airbag sensor and seat rail is 1.3 mm (0.0512 in.).

    5. Connect the connector.

    6. Install the wire harness to the 2 clamps.

    7. Check that there is no looseness in the installed parts of the seat position airbag sensor.

  2. INSTALL SEAT POSITION AIRBAG SENSOR (for Power Seat)


    1. A0028OR

      Engage the pin to install the seat position airbag sensor to the seat slide position sensor protector as shown in the illustration.

    2. A0027OPC04
      *1 Seat Position Airbag Sensor
      *a Feeler Gauge
      *b 1.3 mm (0.0512 in.)
      *c Seat Rail

      Using a 1.3 mm (0.0512 in.) feeler gauge, temporarily install the seat position airbag sensor with the "TORX" bolt and nut.

      Note


      • If the seat position airbag sensor has been dropped, or there are any cracks, dents or other defects in the case or connector, replace the seat position airbag sensor with a new one.

      • When installing the seat position airbag sensor, be careful that the SRS wiring does not interfere with or is pinched between other parts.

    3. Using a T30 "TORX" socket wrench, tighten the "TORX" bolt and nut.

      Torque:
      "TORX" Bolt
      8.0 N*m  { 82 kgf*cm, 71 in.*lbf }

    4. Make sure that the clearance between the seat position airbag sensor and seat rail is 1.3 mm (0.0512 in.).

    5. Connect the connector.

    6. Install the wire harness to the 2 clamps.

    7. Check that there is no looseness in the installed parts of the seat position airbag sensor.

  3. INSTALL FRONT SEAT CUSHION SHIELD (for Manual Seat)

    Click here

  4. INSTALL VERTICAL ADJUSTING HANDLE (for Manual Seat)

    Click here

  5. INSTALL RECLINING ADJUSTER RELEASE HANDLE (for Manual Seat)

    Click here

  6. INSTALL FRONT SEAT ASSEMBLY LH

    for Manual Seat: Click here

    for Power Seat: Click here

  7. PERFORM DIAGNOSTIC SYSTEM CHECK

    Click here