FRONT SEAT OUTER BELT ASSEMBLY INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. INSTALL FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY


    1. A002AESN01

      Engage the guide and temporarily install the front shoulder belt anchor adjuster assembly with the 2 bolts.

    2. Fully tighten the bolt (A) first, then the bolt (B) to install the front shoulder belt anchor adjuster assembly.

      Torque:
      42 N*m  { 428 kgf*cm, 31 ft.*lbf }

  2. INSPECT FRONT SEAT OUTER BELT ASSEMBLY

    Click here

  3. INSTALL FRONT SEAT OUTER BELT ASSEMBLY


    1. A002862N01

      Temporarily install the front seat outer belt assembly with the 2 bolts.

    2. Fully tighten the bolt (A) first, then the bolt (B).

      Torque:
      Bolt (A)
      12.5 N*m  { 127 kgf*cm, 9 ft.*lbf }
      Bolt (B)
      42 N*m  { 428 kgf*cm, 31 ft.*lbf }
    3. A002CIEC01
      *a Locking Button
      *b Lock

      Connect the pretensioner connector and lock the locking button as shown in the illustration.

      Note

      Securely lock the locking button.

    4. Connect the shoulder anchor of the front seat outer belt assembly with the nut.

      Torque:
      42 N*m  { 428 kgf*cm, 31 ft.*lbf }

    5. Check that the ELR locks.

      Note

      The check should be performed with the front seat outer belt assembly installed.


      1. With the belt assembly installed, check that the belt locks when it is pulled out quickly.

  4. INSTALL CENTER PILLAR GARNISH

    Click here

  5. CONNECT FRONT SEAT OUTER BELT ASSEMBLY


    1. A0028TK

      Connect the floor anchor of the front seat outer belt assembly with the bolt.

      Torque:
      42 N*m  { 428 kgf*cm, 31 ft.*lbf }

  6. INSTALL LOWER CENTER PILLAR GARNISH

    Click here

  7. CONNECT REAR DOOR OPENING TRIM WEATHERSTRIP

    Click here

  8. INSTALL REAR DOOR SCUFF PLATE

    Click here

  9. INSTALL REAR OUTER SEAT TRACK BRACKET COVER

    Click here

  10. CONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP

    Click here

  11. INSTALL FRONT DOOR SCUFF PLATE

    Click here

  12. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  13. INSPECT SRS WARNING LIGHT

    Click here