FRONT SEAT OUTER BELT ASSEMBLY REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. REMOVE FRONT DOOR SCUFF PLATE

    Click here

  4. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP


    1. Disconnect the front door opening trim weatherstrip.

  5. REMOVE REAR OUTER SEAT TRACK BRACKET COVER

    Click here

  6. REMOVE REAR DOOR SCUFF PLATE

    Click here

  7. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP


    1. Disconnect the rear door opening trim weatherstrip.

  8. REMOVE LOWER CENTER PILLAR GARNISH

    Click here

  9. DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY


    1. A00288Z

      Remove the bolt to disconnect the floor anchor of the front seat outer belt assembly.

  10. REMOVE CENTER PILLAR GARNISH

    Click here

  11. REMOVE FRONT SEAT OUTER BELT ASSEMBLY


    1. A0029X1

      Remove the nut and disconnect the shoulder anchor of the front seat outer belt assembly.

    2. A0029ABC01
      *a Protective Tape
      *b Locking Button
      *c Release

      Using a screwdriver, pull out the locking button as shown in the illustration to release the lock and disconnect the pretensioner connector as shown in the illustration.

      Tech Tips

      Tape the screwdriver tip before use.

    3. A002862

      Remove the 2 bolts and front seat outer belt assembly.

  12. REMOVE FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY


    1. A002AES

      Remove the 2 bolts.

    2. Disengage the guide to remove the front shoulder belt anchor adjuster assembly.