SHIFT LEVER REMOVAL

PROCEDURE


  1. SECURE VEHICLE


    1. Fully apply the parking brake and chock a wheel.

      CAUTION:


      • Make sure to apply the parking brake and chock a wheel before performing this procedure.

      • If the vehicle is not secure and the shift lever is moved to N, the vehicle may suddenly move, possibly resulting in an accident or serious injury.

      A0028FQ

  2. REMOVE SHIFT LEVER CAP


    1. A0027YD

      Using a screwdriver with its tip wrapped with protective tape, disengage the 2 claws to remove the shift lever cap from the shift position indicator.

      Note

      Be careful not to damage the shift lever cap and shift position indicator.

  3. REMOVE CONSOLE BOX ASSEMBLY

    Click here

  4. REMOVE SHIFTING HOLE BEZEL


    1. A002820

      Disconnect the shift position indicator connector.

    2. A002806

      Remove the 5 screws and shifting hole bezel from the upper console panel sub-assembly.

  5. REMOVE SHIFT POSITION INDICATOR


    1. A002997

      Disengage the claw and 2 guides and remove the shift position indicator from the shifting hole bezel.

  6. REMOVE NO. 2 SWITCH HOLE BASE

    Click here

  7. REMOVE FRONT NO. 2 CONSOLE BOX INSERT

    Click here

  8. REMOVE CONSOLE BOX INSERT

    Click here

  9. REMOVE NO. 2 CONSOLE BOX MOUNTING BRACKET


    1. A002BKX

      Disengage the clamp from the No. 2 console box mounting bracket.

    2. A002A98

      Remove the 2 screws and No. 2 console box mounting bracket from the transmission floor shift assembly.

  10. REMOVE TRANSMISSION FLOOR SHIFT ASSEMBLY


    1. Move the shift lever to N.

    2. A0028URC01
      *a Transmission Control Switch Connector
      *b Shift Lock Control ECU Connector

      Disconnect the transmission control switch connector.

    3. Disconnect the shift lock control ECU connector.

    4. A002BNU

      Separate the transmission control cable assembly from the transmission floor shift assembly.

    5. A0027WDC01
      *a Counterclockwise

      Rotate the nut counterclockwise approximately 180° and, while holding the nut in that position, separate the transmission control cable assembly from the transmission floor shift assembly.

    6. A0027ZV

      Remove the 4 nuts and transmission floor shift assembly from the shift lever support.