DIFFERENTIAL OIL SEAL(for LH Side) REPLACEMENT

PROCEDURE


  1. REMOVE NO. 1 ENGINE UNDER COVER

    Click here

  2. SEPARATE FRONT FENDER LINER LH

    Click here

  3. REMOVE FRONT FENDER APRON SEAL LH

    Click here

  4. DRAIN AUTOMATIC TRANSAXLE FLUID


    1. A002CIX

      Remove the refill plug and gasket from the automatic transaxle assembly.

    2. A002BGQ

      Using a 6 mm hexagon socket wrench, remove the overflow plug and gasket from the automatic transaxle oil pan sub-assembly.

    3. A00292NC20
      *1 No. 1 Transmission Oil Filler Tube
      *a Hexagon Socket Wrench
      *b Overflow Plug Hole

      Using a 6 mm hexagon socket wrench, remove the No. 1 transmission oil filler tube from the automatic transaxle oil pan sub-assembly.

    4. Drain automatic transaxle fluid from the automatic transaxle assembly.

    5. A00292NC21
      *1 No. 1 Transmission Oil Filler Tube
      *a Hexagon Socket Wrench
      *b Overflow Plug Hole

      Using a 6 mm hexagon socket wrench, install the No. 1 transmission oil filler tube to the automatic transaxle oil pan sub-assembly.

      Torque:
      1.7 N*m  { 17 kgf*cm, 15 in.*lbf }
    6. A002BGQ

      Using a 6 mm hexagon socket wrench, temporarily install the gasket and overflow plug to the automatic transaxle oil pan sub-assembly.

      Tech Tips

      Reuse the old gasket as the overflow plug will be removed again to adjust the fluid level.

    7. A002CIX

      Temporarily install the gasket and refill plug to the automatic transaxle assembly.

      Tech Tips

      Reuse the old gasket as the refill plug will be removed again to adjust the fluid level.

  5. REMOVE FRONT DRIVE SHAFT ASSEMBLY LH

    Click here

  6. REMOVE FRONT DRIVE SHAFT OIL SEAL LH

    A0029B5N02

    1. Using SST, remove the transaxle case oil seal LH from the automatic transaxle assembly.

      SST
      09308-00010

      Note

      Be careful not to damage the transaxle case sub-assembly.

  7. INSTALL FRONT DRIVE SHAFT OIL SEAL LH


    1. A0029XLN02

      Using SST and a hammer, install a new transaxle case oil seal LH to the automatic transaxle assembly.

      SST
      09316-10010
      09950-70010   ( 09951-07100 )
      Standard Depth
      -0.5 to 0.5 mm (-0.0197 to 0.0196 in.)

      Note


      • Make sure that the transaxle case oil seal LH is installed in the correct direction.

      • Do not damage the transaxle case oil seal LH lip.

    2. Coat the lip of the transaxle case oil seal LH with MP grease.

  8. INSTALL FRONT DRIVE SHAFT ASSEMBLY LH

    Click here

  9. ADD AUTOMATIC TRANSAXLE FLUID

    Click here

  10. INSTALL FRONT FENDER APRON SEAL LH

    Click here

  11. INSTALL FRONT FENDER LINER LH

    Click here

  12. INSTALL NO. 1 ENGINE UNDER COVER

    Click here