TRANSMISSION CONTROL CABLE

INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY

Note

Before installing the transmission control cable assembly, check that the park/neutral position switch assembly and the shift lever are in neutral.

Pass the transmission control cable assembly from the cabin to the engine compartment.
Install the transmission control cable assembly with the 3 bolts.

Torque:

5.0 N*m { 51 kgf*cm, 44 in.*lbf }
Install the dash panel insulator to the original position.
Connect the transmission control cable assembly to the No. 3 transmission control cable bracket.
Install a new clip to the No. 1 transmission control cable bracket.

*a	Claw A
*b	Claw B
*c	Transmission Control Cable Assembly

Connect the transmission control cable assembly to the No. 1 transmission control cable bracket.

Note

Make sure that the claws A on the clip are securely fit into the No. 1 transmission control cable bracket holes.
Make sure that the transmission control cable assembly is securely installed inside of the claws B of the clip.

Connect the transmission control cable assembly to the transmission control shaft lever with the nut.

Torque:

12 N*m { 122 kgf*cm, 9 ft.*lbf }

Note

Before connecting the transmission control cable assembly, check that the park/neutral position switch assembly and the shift lever are in neutral.
Engage the wire harness clamp.

*a	Slider
*b	Lock Piece
*c	Slide
*d	Pull

Slide the slider of the transmission control cable assembly in the direction indicated by the arrow in the illustration and pull the lock piece outward.

*a	Lock Nut
*b	Push in
*c	Stopper

Turn the lock nut of the transmission control cable assembly counterclockwise. While holding the lock nut, push in the stopper.

*a Stopper

Install the outer part of the transmission control cable assembly to the transmission floor shift assembly.

Note

After installation, check that the outer part of the cable lock is protruding beyond portion A-A as shown in the illustration.
*a Lock Piece

*b Adjuster Case

Install the end of the transmission control cable assembly to the transmission floor shift assembly.
Note
- Check that the lock piece is pulled out.
- Install the cable end all the way to the base of the transmission floor shift assembly pin.
Push the lock piece into the adjuster case.
Note
- Check that the park/neutral position switch assembly and shift lever are in neutral.
- Securely push in the lock piece until the slider lock is engaged.

CONNECT NO. 1 PARKING BRAKE CABLE ASSEMBLY (for RHD)

Connect the No. 1 parking brake cable assembly with the 3 nuts.

Torque:

6.0 N*m { 61 kgf*cm, 53 in.*lbf }
Install the floor carpet to the original position.