4WD CONTROL ECU(for LHD) INSTALLATION

PROCEDURE

1. INSTALL 4WD ECU ASSEMBLY

   
   

   1. Install the 4WD ECU assembly to the bracket with the nut.

      Torque:

      7.5 N*m  { 76 kgf*cm, 66 in.*lbf }

   2. Connect the 4WD ECU assembly connector.

2. INSTALL WIRE HARNESS CLAMP BRACKET

   Click here

3. INSTALL INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY WITH MAIN BODY ECU

   Click here

4. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY

   Click here

5. INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH

   Click here

6. INSTALL FRONT DOOR SCUFF PLATE LH

   Click here

7. INSTALL INSTRUMENT PANEL FINISH PANEL END LH

   Click here

8. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

   Click here

9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

   Note

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

   Click here