FRONT CAMERA REMOVAL

CAUTION / NOTICE / HINT

Note


  • When replacing the forward recognition camera, replace it with a new one.

  • Do not touch the camera lens or the front windshield glass in front of the camera.

  • If the forward recognition camera has been struck or dropped, replace it with a new one.

  • When replacing the windshield glass of a vehicle equipped with a forward recognition camera, make sure to use a Toyota genuine part. If a non-Toyota genuine part is used, the forward recognition camera may not be able to be installed due to a missing bracket. Also, the dynamic radar cruise control system, lane departure alert system, pre-collision system, forward recognition camera system or automatic high beam system may not operate properly due to a difference in the transmissivity or black ceramic border.

PROCEDURE


  1. REMOVE NO. 2 FORWARD RECOGNITION COVER


    1. A002ATON01

      Pull the No. 2 forward recognition cover in the direction indicated by the arrow (1) in the illustration to disengage the 2 claws.

      Note

      If these claws are disengaged separately, they may break. Insert a molding remover between them and pull it down to disengage the claws simultaneously.

    2. Pull the No. 2 forward recognition cover in the direction indicated by the arrow (2) in the illustration to disengage the 2 guides and remove the No. 2 forward recognition cover.

  2. REMOVE NO. 1 FORWARD RECOGNITION COVER


    1. A002B20

      Disengage the 2 clips and 2 guides to remove the No. 1 forward recognition cover as shown in the illustration.

      Note

      To avoid damaging the guides, always slide the No. 1 forward recognition cover parallel to the windshield glass.

  3. REMOVE FORWARD RECOGNITION LATCH


    1. A0029XXN01

      Disengage the 2 claws in the direction indicated by the arrow (1) in the illustration.

    2. Disengage the 4 guides in the direction indicated by the arrow (2) in the illustration to remove the forward recognition latch.

  4. REMOVE FORWARD RECOGNITION CAMERA


    1. A002BAF

      Disconnect the connector.

    2. Disengage the 4 guides and remove the forward recognition camera as shown in the illustration.

      Note


      • Do not pull the harness forcibly when disconnecting the connector.

      • If the forward recognition camera bracket is deformed or damaged, replace it together with the windshield glass.

      • If the forward recognition camera has been struck or dropped, replace it with a new one.

      • Do not apply excessive force.