DYNAMIC RADAR CRUISE CONTROL SYSTEM(for 2GR-FKS), Diagnostic DTC:U010087, U012287, U110487

DTC Code DTC Name
U010087 Lost Communication With ECM/PCM "A" Missing Message
U012287 Lost Communication with Vehicle Dynamics Control Module Missing Message
U110487 Lost Communication with Driving Support ECU Missing Message

DESCRIPTION

The ECM communicates with each sensor and ECU via CAN communication.

If any malfunction is detected in a CAN communication circuit, one or more CAN communication system DTCs are stored.

DTC No. Detection Item DTC Detection Condition Trouble Area
U010087 Lost Communication With ECM/PCM "A" Missing Message While the vehicle speed is 36 km/h (22 mph) or more and the dynamic radar cruise control system is operating, the ECM continuously receives a communication cut-off signal from the skid control ECU (brake actuator assembly) for approximately 1 second or more.

  • CAN communication system

  • ECM

  • Skid control ECU (brake actuator assembly)
U012287 Lost Communication with Vehicle Dynamics Control Module Missing Message When the engine switch is on (IG) and the dynamic radar cruise control system is operating, a communication error between the skid control ECU (brake actuator assembly) and the ECM is detected for approximately 2.6 seconds or more.

  • CAN communication system

  • ECM

  • Skid control ECU (brake actuator assembly)
U110487 Lost Communication with Driving Support ECU Missing Message While the vehicle speed is 36 km/h (22 mph) or more and the dynamic radar cruise control system is operating, a communication error between the driving support ECU assembly and ECM is detected for 1 second or more.

  • CAN communication system

  • ECM

  • Driving support ECU assembly

PROCEDURE


  1. CHECK FOR DTCs


    1. Clear the DTCs.

      Click here


      Powertrain > Radar Cruise1 > Clear DTCs

    2. Perform the following to make sure that the DTC detection conditions are met.

      Tech Tips

      If the following conditions are not met, the system cannot detect the malfunction.


      1. Turn the engine switch on (IG).

      2. Turn the dynamic radar cruise control system on using the cruise control main switch (ON-OFF button).

      3. Drive the vehicle at 36 km/h (22 mph) or more for 5 seconds or more.

    3. Check for DTCs.

      Click here


      Powertrain > Radar Cruise1 > Trouble Codes
      Result
      Result Proceed to
      DTC U010087, U012287 and U110487 are not output A
      DTC U010087, U012287 or U110487 is output B

    A

    USE SIMULATION METHOD TO CHECK Click here

    B

    GO TO CAN COMMUNICATION SYSTEM Click here