STARTER REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. REMOVE RADIATOR SIDE DEFLECTOR SEAL LH

    Click here

  4. REMOVE RADIATOR SIDE SEAL RH

    Click here

  5. REMOVE COOL AIR INTAKE DUCT SEAL

    Click here

  6. REMOVE V-BANK COVER SUB-ASSEMBLY

    Click here

  7. REMOVE BATTERY

    Click here

  8. REMOVE INLET AIR CLEANER ASSEMBLY

    Click here

  9. REMOVE AIR CLEANER ASSEMBLY WITH AIR CLEANER HOSE

    Click here

  10. REMOVE STARTER ASSEMBLY


    1. A0029GJ

      Disconnect the starter assembly connector.

    2. Open the terminal cap.

    3. Remove the nut and disconnect terminal 30.

    4. A00274I

      Type A:


      1. Remove the 2 bolts and starter assembly.

    5. A0026YQ

      Type B:


      1. Remove the 2 nuts and the starter assembly.

      2. Using an E8 "TORX" socket wrench, remove the 2 stud bolts from the automatic transaxle assembly.