IGNITION SWITCH INSPECTION

PROCEDURE


  1. INSPECT IGNITION OR STARTER SWITCH ASSEMBLY


    1. A0027CAC03
      *a

      Component without harness connected

      (Ignition or Starter Switch Assembly)

      *b LOCK
      *c ACC
      *d ON
      *e START

      Check the resistance.


      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        Between all terminals LOCK 1 MΩ or higher
        5 (AM1) - 7 (ACC) ACC Below 1 Ω
        5 (AM1) - 7 (ACC) - 8 (IG1) ON Below 1 Ω
        3 (IG2) - 4 (AM2)
        5 (AM1) - 6 (ST1) - 8 (IG1) START Below 1 Ω
        2 (ST2) - 3 (IG2) - 4 (AM2)

        If the result is not as specified, replace the ignition or starter switch assembly.