STARTER REASSEMBLY

PROCEDURE


  1. INSTALL PLANETARY GEAR


    1. A002996C01
      B003ZIE High-temperature Grease

      Apply high-temperature grease to the planetary gears and planetary shaft pins.

    2. Install the 3 planetary gears.

  2. INSTALL STARTER ARMATURE ASSEMBLY


    1. A0029S1C01
      B003ZIE High-temperature Grease

      Apply high-temperature grease to the starter armature shaft.

    2. A0027VPC02
      B003ZIE High-temperature Grease

      Apply high-temperature grease to the washer and bearing shown in the illustration.

    3. Install the starter armature assembly to the starter commutator end frame assembly.

    4. A002ATCC07

      Using snap ring pliers, install the washer and a new snap ring.

      Note


      • Be sure to install the snap ring in the armature shaft groove securely.


      • Be sure to properly install the snap ring because it expands easily.

    5. A0028JOC10
      *a Width

      Using a vernier caliper, measure the width of the snap ring end gap as shown in the illustration.

      Maximum Width
      5.0 mm (0.197 in.)

      If the width is greater than the maximum, replace the snap ring with a new one.

  3. INSTALL STARTER COMMUTATOR END FRAME COVER


    1. A00278M

      Install the starter commutator end frame cover to the starter commutator end frame assembly.

  4. INSTALL STARTER ARMATURE PLATE


    1. A002A6UC13
      *a Keyway
      *b Key

      Insert the starter armature plate to the starter yoke assembly.

    2. Align the keyway of the starter armature plate with the key inside the starter yoke assembly, and install the starter armature plate.

  5. INSTALL STARTER COMMUTATOR END FRAME ASSEMBLY

    A00272RC06
    *a Rubber
    *b Cutout

    1. Align the rubber of the starter commutator end frame assembly with the cutout of the starter yoke assembly.

    2. Install the starter commutator end frame assembly to the starter yoke assembly.

      Note

      The magnet of the starter yoke assembly may attract the starter armature assembly when the starter commutator end frame assembly is installed, causing the magnet to break.

  6. INSTALL STARTER YOKE ASSEMBLY


    1. A0028LLC04
      *a Protrusion
      *b Cutout

      Align the protrusion of the starter yoke assembly with the cutout of the repair service starter kit.

    2. Install the starter yoke assembly with the 2 through bolts.

      Torque:
      6.0 N*m  { 61 kgf*cm, 53 in.*lbf }

  7. INSTALL REPAIR SERVICE STARTER KIT


    1. A0028UFC01
      *a Hook
      B003ZIE High-temperature Grease

      Apply high-temperature grease to the plunger.

    2. Hang the hook of the plunger on the drive lever.

    3. A0029JYC01
      B003ZIE High-temperature Grease

      Apply high-temperature grease to the return spring.

    4. Install the magnet switch with the 2 screws.

      Torque:
      7.5 N*m  { 76 kgf*cm, 66 in.*lbf }

    5. Connect the field coil lead wire to the magnet switch with the nut.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }