OIL PRESSURE SWITCH INSTALLATION

PROCEDURE

1. INSTALL ENGINE OIL PRESSURE SWITCH ASSEMBLY

   
   
   1. 

      *1	Adhesive 1344

      Apply adhesive to 2 or 3 threads of the engine oil pressure switch assembly.

      Adhesive
      Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent

   2. Using a 24 mm deep socket wrench, install the engine oil pressure switch assembly.

      Torque:

      15 N*m  { 153 kgf*cm, 11 ft.*lbf }

      Note

      Do not start the engine within 1 hour of installation.

   3. Connect the engine oil pressure switch assembly connector.

   4. Connect the wire harness protector. (w/ Oil Cooler)

2. ADD ENGINE OIL

   Click here

3. INSPECT FOR OIL LEAK

   Click here

4. INSTALL FRONT FENDER APRON SEAL RH

   Click here

5. INSTALL FRONT FENDER LINER RH

   Click here

6. INSTALL NO. 1 ENGINE UNDER COVER

   Click here

7. INSTALL FRONT WHEEL RH