OIL PUMP REASSEMBLY

PROCEDURE


  1. INSTALL FRONT OIL PUMP OIL SEAL


    1. A018LMFN05

      Using SST and a hammer, install a new front oil pump oil seal to the front oil pump body sub-assembly.

      SST
      09350-32014   ( 09351-32140 )

      Note

      The seal end should be level with the outer edge of the front oil pump body sub-assembly.

    2. Coat the lip of the front oil pump oil seal with MP grease.

  2. INSTALL FRONT OIL PUMP BODY O-RING


    1. A018GUN

      Coat a new front oil pump body O-ring with ATF and install it to the front oil pump body sub-assembly.

      Note

      Ensure that the front oil pump body O-ring is not twisted.

  3. INSTALL FRONT OIL PUMP DRIVEN GEAR


    1. A018L88

      Coat the front oil pump driven gear with ATF and install it to the front oil pump body sub-assembly with the marked side facing upward.

  4. INSTALL FRONT OIL PUMP DRIVE GEAR


    1. A018JBJ

      Coat the front oil pump drive gear with ATF, and install it to the front oil pump body sub-assembly with the marked side facing upward.

  5. INSTALL STATOR SHAFT ASSEMBLY


    1. A018IC2N09

      Align each knock pin of the stator shaft assembly with the holes in the front oil pump body sub-assembly and install the stator shaft assembly to the front oil pump body sub-assembly.

    2. Using a T30 "TORX" socket wrench, install the 16 bolts.

      Torque:
      9.3 N*m  { 95 kgf*cm, 82 in.*lbf }
      Bolt Length
      Bolt (A)
      14 mm (0.551 in.)
      Bolt (B)
      26 mm (1.02 in.)

  6. INSPECT FRONT OIL PUMP BODY SUB-ASSEMBLY

    Click here