PARK / NEUTRAL POSITION SWITCH ADJUSTMENT

PROCEDURE


  1. ADJUST PARK/NEUTRAL POSITION SWITCH ASSEMBLY


    1. Remove the transmission control shaft lever.

      Click here

    2. A002A4D

      Loosen the 2 bolts of the park/neutral position switch assembly.

    3. B003Z21C17
      *a Protrusion

      Align the protrusions of the park/neutral position switch assembly.

    4. A002A4D

      Hold the park/neutral position switch assembly in position and tighten the 2 bolts.

      Torque:
      5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

      Note

      After installing the park/neutral position switch assembly, confirm that the 2 protrusions on the park/neutral position switch assembly are aligned.

    5. Install the transmission control shaft lever.

      Click here

    6. After the adjustment, perform the park/neutral position switch assembly operation check.

      Click here