TRANSFER OIL REPLACEMENT

PROCEDURE


  1. DRAIN TRANSFER OIL


    1. A0026YJ

      Remove the No. 1 transfer case plug and gasket from the transfer assembly.

    2. A002AJ4

      Remove the transfer drain plug and gasket and drain the transfer oil.

    3. Install a new gasket and the transfer drain plug.

      Torque:
      49 N*m  { 500 kgf*cm, 36 ft.*lbf }

  2. ADD TRANSFER OIL


    1. A018KGWC01
      *a 0 to 5.0 mm (0 to 0.197 in.)

      Add transfer oil until the oil level is between 0 and 5 mm (0 and 0.197 in.) from the bottom lip of the case plug hole.

      Note


      • When adding transfer oil, make sure that the vehicle is level.

      • Add transfer oil a little at a time, waiting several minutes between each addition of transfer oil.

      • After adding transfer oil, drive the vehicle and recheck the oil level.

      Oil Type
      Toyota Genuine Differential gear oil LT API GL-5 or equivalent
      Viscosity
      SAE 75W-85
      Standard Capacity
      0.8 liters (0.8 US qts, 0.7 Imp.qts)

    2. After waiting for approximately 5 minutes, recheck the oil level.

    3. Install a new gasket and the No. 1 transfer case plug to the transfer assembly.

      Torque:
      49 N*m  { 500 kgf*cm, 36 ft.*lbf }