TRANSFER CASE REAR OIL SEAL REPLACEMENT

PROCEDURE


  1. REMOVE PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY

    Click here

  2. REMOVE TRANSFER EXTENSION HOUSING TYPE T OIL SEAL


    1. A01GEO5E01

      Using SST, remove the transfer extension housing type T oil seal from the transfer assembly.

      SST
      09308-00010

      Note

      Be careful not to damage the transfer extension housing type T oil seal contact surface or the inside surface of the transfer extension housing type T oil seal.

  3. INSTALL TRANSFER EXTENSION HOUSING TYPE T OIL SEAL


    1. A01GEW6E01

      Using SST and a hammer, install a new transfer extension housing type T oil seal to the transfer assembly until it reaches the position shown in the illustration.

      SST
      09325-20010
      Standard Depth
      1.1 to 1.9 mm (0.0434 to 0.0748 in.)

      Note

      Do not tilt the transfer extension housing type T oil seal during installation.

    2. Apply a small amount of MP grease to the lip of the transfer extension housing type T oil seal .

  4. INSTALL PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY

    Click here

  5. INSPECT TRANSFER OIL

    Click here