FUEL SENDER GAUGE ASSEMBLY INSPECTION

PROCEDURE


  1. INSPECT FUEL SENDER GAUGE ASSEMBLY


    1. Check that the float moves smoothly between F and E.

    2. A0029OKC01
      *a

      Component without harness connected

      (Fuel Sender Gauge Assembly)

      Inspect the fuel sender gauge assembly resistance.


      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Float Level Specified Condition
        1 - 2 F 13.5 to 16.5 Ω
        Between F and E 13.5 to 414.5 Ω (Gradually changes)
        E 405.5 to 414.5 Ω

        If the result is not as specified, replace the fuel sender gauge assembly.