REAR CRANKSHAFT OIL SEAL INSTALLATION

PROCEDURE


  1. INSTALL REAR ENGINE OIL SEAL


    1. A002827C01
      *1 Rear Engine Oil Seal Retainer
      *a Oil Seal Protrusion Height

      Apply MP grease to the lip of a new rear engine oil seal.

    2. Using SST and a hammer, tap in the rear engine oil seal.

      SST
      09223-15030
      09950-70010   ( 09951-07150 )
      Oil Seal Protrusion Height
      -0.5 to 0.5 mm (-0.0197 to 0.0197 in.)

      Note


      • Keep the lip free from foreign matter.

      • Do not tap in the rear engine oil seal at an angle.

  2. INSTALL DRIVE PLATE AND RING GEAR SUB-ASSEMBLY


    1. A00293GN01

      Using SST, hold the crankshaft pulley.

      SST
      09213-70011   ( 09213-70020 )
      09330-00021

    2. Clean the 8 bolts and 8 bolt holes.

    3. A0028B8

      Install the No. 1 crankshaft position sensor plate.

      Tech Tips

      Align the pin of the No. 1 crankshaft position sensor plate with the pin hole of the crankshaft.

    4. A0027DRC01
      *1 Drive Plate and Ring Gear Sub-assembly
      *2 Rear Drive Plate Spacer
      B003ZIE Transaxle Side

      Install the drive plate and ring gear sub-assembly and rear drive plate spacer to the crankshaft.

    5. A002C2SC01
      *a Adhesive

      Apply adhesive to 2 or 3 threads at the end of each of the 8 bolts.

      Adhesive
      Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent
    6. A002BS1N01

      Install and uniformly tighten the 8 bolts in several steps in the sequence shown in the illustration.

      Torque:
      83 N*m  { 846 kgf*cm, 61 ft.*lbf }

      Note

      Do not start the engine for at least 1 hour after installing the drive plate and ring gear sub-assembly.

  3. INSTALL AUTOMATIC TRANSAXLE ASSEMBLY (for 2WD)

    When not Using the Engine Support Bridge: Click here

    When Using the Engine Support Bridge: Click here

  4. INSTALL AUTOMATIC TRANSAXLE ASSEMBLY (for AWD)

    When not Using the Engine Support Bridge: Click here

    When Using the Engine Support Bridge: Click here