HEATED OXYGEN SENSOR INSTALLATION

PROCEDURE


  1. INSTALL HEATED OXYGEN SENSOR

    Tech Tips

    Perform "Inspection After Repair" after replacing the heated oxygen sensor.

    Click here


    1. A0027NDC01
      *a Length of SST 30 mm (1.18 in.)
      *b Length of Torque Wrench 260 mm (10.2 in.)

      Using SST, install the heated oxygen sensor to the front exhaust pipe assembly.

      SST
      09224-00010
      Torque:
      without SST [Torque (N*m (kgf*cm, ft.*lbf))]
      44 N*m  { 449 kgf*cm, 32 ft.*lbf }
      with SST [Reading of Torque wrench (N*m (kgf*cm, ft.*lbf))]
      39 N*m  { 398 kgf*cm, 29 ft.*lbf }

      Note

      If the heated oxygen sensor has been struck or dropped, replace it.

      Tech Tips


      • This torque value is effective when SST is parallel to the torque wrench.

      • The "with SST" torque value is effective when using SST with a fulcrum length of 30 mm (1.18 in.).

      • The "with SST" torque value is effective when using a torque wrench with a fulcrum length of 260 mm (10.2 in.).

      • If using a torque wrench with a different length, or connecting the torque wrench and SST at an angle, refer to the alternate torque values.

        Click here

    2. Engage the 3 wire harness clamps.

    3. Connect the heated oxygen sensor connector.

  2. INSTALL FRONT FLOOR COVER LH

    Click here

  3. INSPECT FOR EXHAUST GAS LEAK

    Click here

  4. PERFORM INITIALIZATION


    1. Perform "Inspection After Repair" after replacing the heated oxygen sensor.

      Click here