CRANKSHAFT POSITION SENSOR INSTALLATION

PROCEDURE


  1. INSTALL CRANKSHAFT POSITION SENSOR


    1. B003ZXJC78
      *a Adhesive

      Apply adhesive to 2 or 3 threads of the bolt for the crankshaft position sensor.

      Adhesive
      Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent.
    2. A0028U7C08
      *a O-ring

      Apply a light coat of engine oil to the O-ring of the crankshaft position sensor.

    3. Install the crankshaft position sensor to the timing chain cover sub-assembly with the bolt.

      Torque:
      6.5 N*m  { 66 kgf*cm, 58 in.*lbf }

      Note


      • If the crankshaft position sensor has been struck or dropped, replace it.

      • Make sure that the O-ring is not cracked or does not move out of place during installation.

    4. Connect the crankshaft position sensor connector.

  2. INSPECT FOR ENGINE OIL LEAK

    Click here

  3. INSTALL FRONT FENDER APRON SEAL RH

    Click here