THROTTLE BODY REMOVAL

PROCEDURE


  1. DRAIN ENGINE COOLANT

    Click here

  2. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY

    Click here

  3. REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE


    1. A002BFT

      Disconnect the mass air flow meter sub-assembly connector and disengage the wire harness clamp.

    2. Disengage the hose clamp and disconnect the vacuum switching valve assembly from the No. 1 air cleaner hose.

    3. A002BIC

      Slide the clip and disconnect the ventilation hose from the cylinder head cover sub-assembly.

    4. A002A3U

      Disengage the 2 air cleaner cap clamps.

    5. A002A3X

      Loosen the hose clamp and remove the air cleaner cap with air cleaner hose from the throttle body with motor assembly.

  4. REMOVE THROTTLE BODY WITH MOTOR ASSEMBLY


    1. A00278C

      Disconnect the throttle body with motor assembly connector.

    2. Disengage the fuel tube sub-assembly from the clamp.

    3. A0028K5C01
      *1 No. 1 Water By-pass Hose
      *2 No. 2 Water By-pass Hose

      Slide the 2 clips and disconnect the No. 1 water by-pass hose and No. 2 water by-pass hose from the throttle body with motor assembly.

    4. A00299W

      Remove the 4 bolts and throttle body with motor assembly from the intake manifold.

      Note

      If the throttle body with motor assembly has been struck or dropped, replace it.

  5. REMOVE FUEL HOSE BRACKET


    1. A0027DI

      Remove the bolt and fuel hose bracket from the throttle body with motor assembly.

  6. REMOVE THROTTLE BODY GASKET


    1. A0029LS

      Remove the throttle body gasket from the intake manifold.