INITIALIZATION
Note
Perform Registration (VIN registration or frame number registration) when replacing the ECM.
If the ECM is replaced, register the ECU communication ID for Immobiliser System (w/o Smart Entry and Start System) (Refer to the Service Bulletin for Registration).
Make sure to perform Reset Memory (A/T initialization), when replacing the automatic transaxle assembly, ECM or engine assembly.
When the cable is disconnected from the negative (-) battery terminal, initialize the following system(s) after the cable is reconnected.
| System Name | See Procedure |
|---|---|
| Lane Departure Alert System (w/ Steering Control) | |
| Parking Assist Monitor System | |
| Panoramic View Monitor System | |
| Power Door Lock Control System | |
| Pre-collision System | |
| Air Conditioning System (for Automatic Air Conditioning System) | |
| Air Conditioning System (for Manual Air Conditioning System) | |
| Power Back Door System |
WHEN USING GTS
CAUTION:
Observe the following items for safety reasons:
Before using the GTS, read the instruction manual.
Prevent the GTS cable from being caught on the pedals, shift lever or steering wheel when driving with the GTS connected to the vehicle.
When driving the vehicle for testing purposes using the GTS, 2 persons are required. One is for driving the vehicle, and the other operates the GTS.
IGNITION SWITCH EXPRESSIONS
Tech Tips
The type of ignition switch used on this model differs depending on the specifications of the vehicle. The expressions listed in the table below are used in this section.
| Expression | Ignition Switch (Position) | Engine Switch (Condition) |
|---|---|---|
| Ignition Switch off | LOCK | Off (Lock) |
| Ignition Switch ACC | ACC | On (ACC) |
| Ignition Switch ON | ON | On (IG) |
| Engine Start | START | On (Start) |