EXHAUST MANIFOLD COMPONENTS
ILLUSTRATION
| *1 | FRONT FLOOR COVER LH | *2 | NO. 2 ENGINE UNDER COVER |
ILLUSTRATION
| *A | for 4WD | - | - |
| *1 | PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY | *2 | CENTER NO. 2 SUPPORT BEARING WASHER |
 |
N*m (kgf*cm, ft.*lbf): Specified torque |  |
Do not apply lubricants |
ILLUSTRATION
| *1 | FRONT EXHAUST PIPE ASSEMBLY | *2 | NO. 1 EXHAUST PIPE SUPPORT BRACKET (for Lower Side) |
| *3 | FRONT NO. 3 EXHAUST PIPE SUB-ASSEMBLY | *4 | COMPRESSION SPRING |
| *5 | GASKET | - | - |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
ILLUSTRATION
| *1 | EXHAUST MANIFOLD SUB-ASSEMBLY LH (TWC: Front Catalyst) | *2 | EXHAUST MANIFOLD SUB-ASSEMBLY RH (TWC: Front Catalyst) |
| *3 | EXHAUST MANIFOLD TO HEAD GASKET | *4 | EXHAUST MANIFOLD TO HEAD GASKET LH |
| *5 | MANIFOLD STAY | *6 | NO. 2 ENGINE OIL LEVEL DIPSTICK GUIDE |
| *7 | NO. 2 EXHAUST MANIFOLD HEAT INSULATOR | *8 | NO. 2 MANIFOLD STAY |
| *9 | AIR FUEL RATIO SENSOR (for Bank 1) | *10 | AIR FUEL RATIO SENSOR (for Bank 2) |
| *11 | ENGINE OIL LEVEL DIPSTICK | *12 | O-RING |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
| * | For use with SST | - | - |