WINDSHIELD OUTSIDE MOULDING INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the LH side and RH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. INSTALL WINDSHIELD NO. 3 OUTSIDE MOULDING CLIP

    Tech Tips

    Perform the following procedure only when replacement of a windshield No. 3 outside moulding clip is necessary.


    1. A0020GJ

      Using a riveter with a nose piece, install 5 new windshield No. 3 outside moulding clips.

      Tech Tips

      If the mandrel of the windshield No. 3 outside moulding clip does not come off on the first operation of the rivet gun, slide the rivet gun forward on the mandrel and operate it again.

      Note


      • Do not pry the windshield No. 3 outside moulding clip with the riveter, as this will cause damage to the riveter and mandrel.


      • A0022N1C01
        *a Riveter
        *b Incorrect

        Confirm that the windshield No. 3 outside moulding clips are seated properly against the vehicle body.


      • Do not tilt the riveter when installing the windshield No. 3 outside moulding clip to the vehicle body.

      A0022T2C01
      *a Riveter
      *b Mandrel
      *c Incorrect

    2. Install the windshield glass.

      Click here

  2. INSTALL WINDSHIELD NO. 1 OUTSIDE MOULDING CLIP

    Tech Tips

    Perform the following procedure only when replacement of a No. 1 windshield outside moulding clip is necessary.


    1. Engage the 5 claws to install 5 new windshield No. 1 outside moulding clips to the windshield No. 3 outside moulding clip as shown in the illustration.

      A0022TYC01
      *1 Windshield No. 1 Outside Moulding Clip *2 Windshield No. 3 Outside Moulding Clip

  3. INSTALL WINDSHIELD OUTSIDE MOULDING


    1. A0021D4

      Engage the 13 claws to install the windshield outside moulding.