WINDSHIELD OUTSIDE MOULDING REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the LH side and RH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. REMOVE WINDSHIELD OUTSIDE MOULDING


    1. A0022MHC01
      B003YLR Protective Tape

      Apply protective tape around the windshield outside moulding.

    2. A0020LK

      Using a moulding remover, disengage the 3 claws.

    3. A0021ZU

      Using a moulding remover, disengage the 10 claws and remove the windshield outside moulding.

  2. REMOVE WINDSHIELD NO. 1 OUTSIDE MOULDING CLIP

    Tech Tips

    Perform the following procedure only when replacement of a windshield No. 1 outside moulding clip is necessary.


    1. A0022I7

      Disengage the 5 claws and remove the 5 windshield No. 1 outside moulding clips as shown in the illustration.

  3. REMOVE WINDSHIELD NO. 3 OUTSIDE MOULDING CLIP

    Tech Tips

    Perform the following procedure only when replacement of a windshield No. 3 outside moulding clip is necessary.


    1. Remove the windshield glass.

      Click here

    2. Insert a 4.0 mm (0.157 in.) drill bit into a drill.

    3. A0020ZHC04
      *a Tape

      Tape the 4.0 mm (0.157 in.) drill bit 5.0 mm (0.197 in.) from the tip as shown in the illustration.

      Standard Measurement
      Area Measurement
      A 5.0 mm (0.197 in.)

      Note

      Tape the 4.0 mm (0.157 in.) drill bit to prevent the drill bit from going too deep.

    4. A0020ZXC01
      *a Flange

      Lightly press the drill bit against the windshield No. 3 outside moulding clip to drill off the windshield No. 3 outside moulding clip flanges, and remove the 5 windshield No. 3 outside moulding clips.

      Note


      • Make sure to protect both the inside and outside of the vehicle as the windshield No. 3 outside moulding clip shavings will fly about.

      • Pressing the drill too firmly will cause the windshield No. 3 outside moulding clip to turn and result in the windshield No. 3 outside moulding clip not being drilled through.

      • Prying the windshield No. 3 outside moulding clips with the drill may damage the windshield No. 3 outside moulding clip installation holes or drill bit.

      • Be careful of the drilled windshield No. 3 outside moulding clips, as they may be hot.

    5. Using a vacuum cleaner, remove the windshield No. 3 outside moulding clip fragments and shavings from the drilled areas.