REAR DOOR BELT MOULDING INSTALLATION

CAUTION / NOTICE / HINT

PROCEDURE

1. PRECAUTION

   Note

   After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

   Click here

2. INSTALL REAR DOOR BELT MOULDING ASSEMBLY

   
   

   1. 

      Engage the 4 claws and 2 guides to install the rear door belt moulding assembly as shown in the illustration.

3. INSTALL REAR DOOR GLASS SUB-ASSEMBLY

   Click here

4. INSTALL REAR DOOR QUARTER WINDOW GLASS

   Click here

5. INSTALL REAR DOOR LOWER WINDOW FRAME SUB-ASSEMBLY

   Click here

6. INSTALL REAR DOOR GLASS RUN

   Click here

7. CONNECT REAR DOOR WEATHERSTRIP

   Click here

8. INSTALL REAR DOOR SERVICE HOLE COVER

   Click here

9. INSTALL REAR DOOR INNER GLASS WEATHERSTRIP

   Click here

10. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY

    Click here

11. INSTALL REAR DOOR NO. 1 STIFFENER CUSHION

    Click here

12. INSTALL REAR DOOR NO. 3 ARMREST COVER

    Click here

13. INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL

    Click here

14. INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG

    Click here

15. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

16. INSTALL BATTERY SERVICE HOLE COVER LH

    Click here

17. INSPECT POWER WINDOW OPERATION

    Click here