REAR DOOR BELT MOULDING REMOVAL

CAUTION / NOTICE / HINT

PROCEDURE

1. REMOVE BATTERY SERVICE HOLE COVER LH

   Click here

2. PRECAUTION

   Note

   After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

   Click here

3. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

   CAUTION:

   Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

   Note

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

   Click here

4. REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG

   Click here

5. REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL

   Click here

6. REMOVE REAR DOOR NO. 3 ARMREST COVER

   Click here

7. REMOVE REAR DOOR NO. 1 STIFFENER CUSHION

   Click here

8. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY

   Click here

9. REMOVE REAR DOOR INNER GLASS WEATHERSTRIP

   Click here

10. REMOVE REAR DOOR SERVICE HOLE COVER

    Click here

11. DISCONNECT REAR DOOR WEATHERSTRIP

    Click here

12. REMOVE REAR DOOR GLASS RUN

    Click here

13. REMOVE REAR DOOR LOWER WINDOW FRAME SUB-ASSEMBLY

    Click here

14. REMOVE REAR DOOR QUARTER WINDOW GLASS

    Click here

15. REMOVE REAR DOOR GLASS SUB-ASSEMBLY

    Click here

16. REMOVE REAR DOOR BELT MOULDING ASSEMBLY

    
    

    1. 

       Protective Tape

       Apply protective tape around the rear door belt moulding assembly.

    2. 

       *a	Protective Tape

       Using a screwdriver with its tip wrapped with protective tape, disengage the 4 claws and 2 guides and remove the rear door belt moulding assembly.