FRONT DOOR BELT MOULDING INSTALLATION

CAUTION / NOTICE / HINT

PROCEDURE

1. PRECAUTION

   Note

   After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

   Click here

2. INSTALL FRONT DOOR BELT MOULDING ASSEMBLY

   
   

   1. 

      Engage the 6 claws to install the front door belt moulding assembly.

3. INSTALL FRONT DOOR GLASS RUN

   Click here

4. INSTALL FRONT DOOR GLASS SUB-ASSEMBLY

   Click here

5. INSTALL FRONT DOOR SERVICE HOLE COVER

   Click here

6. INSTALL FRONT DOOR FRONT LOWER FRAME UPPER COVER

   Click here

7. INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH

   Click here

8. INSTALL FRONT DOOR INNER GLASS WEATHERSTRIP

   Click here

9. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY

   Click here

10. INSTALL FRONT DOOR NO. 1 STIFFENER CUSHION

    Click here

11. INSTALL COURTESY LIGHT ASSEMBLY

    Click here

12. INSTALL FRONT DOOR ARMREST COVER

    Click here

13. INSTALL MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)

    Click here

14. INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)

    Click here

15. INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG

    Click here

16. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

17. INSTALL BATTERY SERVICE HOLE COVER LH

    Click here

18. INITIALIZE POWER WINDOW CONTROL SYSTEM

    Click here

19. INSPECT POWER WINDOW OPERATION

    Click here