FRONT BUMPER(for Sport Package) REMOVAL

CAUTION / NOTICE / HINT

Tech Tips

When the front bumper is damaged or deformed due to an accident or contact with other objects, etc., or the bumper installation area on the body is repaired, it is necessary to perform millimeter wave radar sensor adjustment.

Click here

PROCEDURE


  1. PRECAUTION

    CAUTION:

    Be sure to read Precaution thoroughly before servicing.

    Click here

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative(-) auxiliary battery terminal notices before proceeding with work.

    Click here

  2. REMOVE BATTERY SERVICE HOLE COVER LH

    Click here

  3. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  4. REMOVE COOL AIR INTAKE DUCT SEAL

    Click here

  5. REMOVE FRONT BUMPER ASSEMBLY


    1. B003XWHC02
      B003YLR Protective Tape

      Apply protective tape around the front bumper assembly as shown in the illustration.

    2. B003YLGC03
      *1 Pin Hold Clip
      *a 90°

      Using a screwdriver, turn the pin 90 degrees and remove the pin hold clip.

      Tech Tips

      Use the same procedure for the RH side and LH side.

    3. Remove the clip.

      Tech Tips

      Use the same procedure for the RH side and LH side.

    4. B003XWO

      Remove the screw.

      Tech Tips

      Use the same procedure for the RH side and LH side.

    5. B003XXC

      Remove the 8 screws.

    6. B003Y12

      Remove the 3 bolts.

    7. Remove the 2 clips.

    8. B003YR4

      w/ Lexus Safety System+:


      1. Disconnect the connector.

    9. B003YGD

      Disengage the 2 claws as shown in the illustration.

      Tech Tips

      Use the same procedure for the RH side and LH side.

    10. Pull back the side of the front bumper assembly and disconnect each connector.

      Note

      Do not apply excessive force when pulling back the front bumper assembly.

    11. B003XYYC02
      *a Push

      w/ Headlight Cleaner System:


      1. Disengage the claw and disconnect the washer hose from the headlight cleaner hose as shown in the illustration.

        Tech Tips

        Use a container to collect the washer fluid.

    12. B003YFP

      Disengage the 2 claws and 12 guides to remove the front bumper assembly as shown in the illustration.